How To Install

*Prior to installation, it's advisable to test and verify that all LEDs are functioning correctly. Not doing so will void the warranty!*

_________________________________________________________________________________________

Preparation:

Safely lift the car using a jack and clean the underside with isopropyl alcohol and a rag. Ensure the surface is completely clean and dry before proceeding.
Place the underglow lights alongside your car, starting from the front and moving towards the rear.
Make sure the arrows on the lights are facing to the rear of the car.
Avoid gluing anything at this stage. If glued it will void the warranty! Make sure to test everything before gluing.

Loosen all screws on the back of the controller and wire it following the provided diagram (see below).
Attach the Stripped Connector to the right side of the controller, matching the colors. Black to black & red to red. However, yellow goes to green.
Connect the relay and fuse cable to the left side of the controller, then to the battery.
The red wire connects to the positive terminal of the battery, and the black wire to the negative terminal. Ensure the connections are tight.

Once you are done testing the kit and if everything works properly, you can proceed to tidy up the wiring for a more professional look. If you encounter any issues, please contact us at Aeroglowco@gmail.com for assistance.

Securely attach the Bluetooth controller and relay using the provided mounting equipment.
Route the switch through an existing grommet in the firewall and mount it in a convenient location for easy access.

Once the surface is prepared, mount the underglow strips and apply pressure to ensure they adhere properly.
Run the wires in a safe location, preferably behind the fender liners, to protect them from damage.